Installation:
All of our OEM converter have to be installed ACCURATELY inside the strobe or housing. These units are NOT plug and play. Normaly, the original bulkhead cables have to be CUT and SPLICED. The pinout of the bulkhead needs to be evaluated with a meter tester and our supplied cables have to be SOLDERED at the bulkheads. The cables need careful installation, as well. Keep all loose cables away from the housing O-ring! The converter PCB has to be installed protected against water and fingers. These are "nacked" PCB boards, they require careful handling. If you can not do the installation please find someone who can do it correctly!
More information required for OEM installation:
Pinout of cameras strobe connector (View from above):
 |
 |
Pinout of OEM converter Mk. 1 (View onto PCB:
Pinout of strobe connectors:
) |
) |
) |
|
Nikonos-connector
|
Sea&Sea Motormarine connector
|
Sea&Sea connector for "DUO"-strobes
|
Pictures of strobe connectors:
) |
) |
) |
|
Nikonos-connector
|
Sea&Sea Motormarine connector
|
Sea&Sea connector for "DUO"-strobes
|
Important:
- All converters communicate with the camera using high-speed data lines. It’s essential that all lines to the camera have a low impendance (<10Ohm).
- make sure that you have a perfect GND level within all parts of the system.
- GND, TRG and QNC MUST be connected in order to get the converter working