Dimensions: 33mm x 25mm x 14mm

The iTTL converter is only available as an OEM module and was developed for housing and strobe manufactures. A fully equiped camera connector is required (5 wires), an optional connector will be available if your housing does not have one already. The strobes will be connected with three wires (or four if you have an Inon Z220).

Features iTTL-mode:

• balanced exposures, more than 200 power levels are used for maximum resolution
• FEC (flash exposure compensation) is supported, of course

The iTTL mode requires double-flash compatible strobes:

• By selecting the "REAR" mode of the camera, the manual mode will be activated
• only the mainflash will be triggered from the converter, manual power settings at the strobe can be used
• additionally, 10 manual settings can be controlled using the cameras FEC value: 1/1, 1/2, 1/4, 1/8, 1/16, 1/32, 1/64 and intermediate values. The strobe remains in TTL in this mode
• perfect for working manually with strobes with only a few manual setting

The manual mode will work with ALL kind of Nikon-TTL strobes like Subtronic Gamma, Ikelite 400, Hartenberger 250 TTL or Nikon SB-105, SB-104.

Installation:

All of our OEM converter have to be installed ACCURATELY inside the strobe or housing. These units are NOT plug and play. Normaly, the original bulkhead cables have to be CUT and SPLICED. The pinout of the bulkhead needs to be evaluated with a meter tester and our supplied cables have to be SOLDERED at the bulkheads. The cables need careful installation, as well. Keep all loose cables away from the housing O-ring! The converter PCB has to be installed protected against water and fingers. These are "nacked" PCB boards, they require careful handling. If you can not do the installation please find someone who can do it correctly!