)
Dimensions: 33mm x 25mm x 14mm
The iTTL converter is only available as an OEM module and was developed for housing and strobe manufactures. A fully equiped camera connector is required (5 wires), an optional connector will be available if your housing does not have one already. The strobes will be connected with three wires (or four if you have an Inon Z220).
Features iTTL-mode:
-
balanced exposures, more than 200 power levels are used for maximum resolution
-
FEC (flash exposure compensation) is supported, of course
The iTTL mode requires double-flash compatible strobes:
| Nikon D70/D70s | Supported strobes |
| Nikon D80 | Supported strobes |
| Nikon D50 | Supported strobes |
| Nikon D2x | Supported strobes |
| Nikon D200 | Supported strobes |
| Nikon D300 | Supported strobes |
Users of older converters can send thier unit for a free update (newer cameras, improved power saving code).
Features in special manual mode:
- By selecting the "REAR" mode of the camera, the manual mode will be activated
- only the mainflash will be triggered from the converter, manual power settings at the strobe can be used
-
additionally, 10 manual settings can be controlled using the cameras FEC value: 1/1, 1/2, 1/4, 1/8, 1/16, 1/32, 1/64 and intermediate values. The strobe remains in TTL in this mode
-
perfect for working manually with strobes with only a few manual setting
The
manual mode will work with ALL kind of Nikon-TTL strobes like Subtronic
Gamma, Ikelite 400, Hartenberger 250 TTL or Nikon SB-105, SB-104.
)